#Omnigraffle pro units mm software#

#Omnigraffle pro units mm software#

While this work revealed a broad spectrum of challenges encountered by newcomers to 3D printing, the participants in the study varied widely in experience, motivation, software used, and task undertaken.

However, Hudson et al.’s investigation of newcomers to 3D printing sheds important light on the subject, revealing problems with end-user motivation, domain knowledge, and the use of 3D modeling software. While many researchers have created design tools that enable domain-specific augmented fabrication(see sec:relatedwork), the evidence in the literature of novice augmented fabricationdesign activity is largely incidental to studies of other matters. Examples include bicycle pedals, equipment for small farms, and hand grips for accessibility, among many others. One of the major activities undertaken by early-adopter end-user makers is augmented fabrication -designing and fabricating new objects that work with existing artifacts. Much as the introduction of personal computers into the home enabled a new category of “end-user programmer”, so 3D printing is bringing into being the end-user maker and a concomitant set of new challenges and opportunities. 3D printers are swiftly becoming inexpensive enough to be accessible to the everyday consumer.